[Ikeda, Nakagaki-san]
BIO cable connection survey
Conclusion :
BIO4 RightB was confirmed to match the free number CBI(O)_H32_C4 in the model file.
Contents :
Investigated the BIO cable connection of IYV.
BIO is assigned from No.1.
I checked inside the I/O chassis and it was the same.
Below is the list of cable names.
| White Cable Label | Black Cable Label | |
| IP-F0 B-OUT | CN A BIO1 Left A | |
| IP-F0 B-IN | CN A BIO1 Right A | |
| GAS B-OUT | CN B BIO1 Left B | |
| GAS B-IN | CN B BIO1 Right B | |
| MNH B-OUT | MNH B-OUT BIO2 Left A | |
| MNH B-IN | MNH B-IN BIO2 Right A | |
| MN IMV B-OUT, | MN IMV B-OUT BIO2 Left B | |
| MN IMV B-IN | MN IMV B-IN BIO2 Right B | |
| IMH B-OUT | IMH B-Out BIO3 Left A | |
| IMH B-IN | CN A BIO3 Right A | |
| IM Dump B-OUT | CN B BIO3 Left B | |
| IM Dump B-IN | CN B BIO3 Right B | |
| TM B-OUT | CN A BIO4 Left A | |
| TM B-IN | TM B-IN BIO4 Right A | |
| Blank B-OUT | Blank B-OUT BIO4 Left B | not connected |
| Blank B-IN | Blank B-IN BIO4 Right B | not connected |
| BFV B-OUT | CN A BIO5 Left A | |
| BFV B-IN, | BFV B-IN BIO5 Right A | |
| BFH B-OUT | BFH B-OUT BIO5 Left B | |
| BFH B-IN | BFH B-IN BIO5 Right B |
Check procedure
K1:VIS-ITMY_BIO_CDCTRL_NOTUSE_WD_RESET OFF->ON
Verify that K1:VIS-ITMY_BIO_CDCTRL_NOTUSE_DIO_OUT is set to 0 to 65536.
On the model, In17 (starting at 1) = Binary IO Checker bord, I confirmed that No.16 (starting at 0) is ON (LED lights up).
I confirmed that the LED turns off when I set it to OFF.
